Precision Mold Design & Manufacturing

Swing Blanking Die for Zero-Scrap Trapezoid Blanks ±18.75°

Model: N/A

3D model of Swing Blanking Die for Zero-Scrap Trapezoid Blanks ±18.75°

Tính năng nổi bật

Swing blanking die that cuts 2 mm steel strip into nested trapezoid blanks with zero scrap: a pneumatic cylinder swings the blade unit ±18.75° after every stroke. Rotate the animated 3D model right on this page.

  • The blade unit turns about a centre pivot: after every stroke a Festo DSBC-50-100 air cylinder, through a lever, swings the upper blades, lower blades and stripper to the opposite angle, ±18.75°.
  • The trapezoid blanks nest into each other, so the whole strip is used with no scrap between blanks; the blank length is set by the feeder pitch.
  • Two solid stops fix the swing angle (the cylinder uses only 79 of its 100 mm stroke) and two M12 proximity sensors confirm the position to the PLC before the press strokes.
  • Four ≈400 mm blades form one cutting line through the pivot; the stripper clamps the strip on 5 gas springs, and upper and lower blades always swing together on 4 dedicated guide pins.
  • Standard 1067 × 610 mm die set with 4 Ø63.5 guide pins and shoulder bushings; blades in SKD11 at 58–62 HRC, plates in S50C to keep cost down; standard cylinder, sensors and gas springs.
  • Built to your requirements: send the blank drawing, material and thickness, coil width, volume and press data, and ZINITEK will propose the die that fits your cost.