Precision Mold Design & Manufacturing

Compound Blanking & 4-Hole Piercing Die for 3.2 mm Steel Lever

Model: N/A

3D model of Compound Blanking & 4-Hole Piercing Die for 3.2 mm Steel Lever

Tính năng nổi bật

Compound die for a 119.6 × 59.4 × 3.2 mm SPHC steel lever with 4 holes: the outline is blanked and all 4 holes pierced in one stroke, giving a flat part with hole-to-edge positions fixed by the die. View and rotate the animated 3D model on the page.

  • Compound die: the blanking punch in the upper die doubles as the piercing die for 4 pins; the die plate and the 4 fixed piercing punches Ø5.5–Ø6.5 sit in the lower die — one stroke delivers a finished blank with outline and holes in one datum.
  • Spring stripper around the punch on 4 rectangular-wire die springs 40 × 40, compressed 7 mm at bottom dead centre: it clamps the 3.2 mm strip flat before the cut and strips it off the punch on the up-stroke.
  • Blank-shaped knockout pad under the die (5 mm travel) lifts the part flush with the die face when the die opens; the skeleton carries the part out and it drops at the die-plate end on the next stroke.
  • Entry guide with 2 hold-down rails, 2 mm strip channel in the die plate and 2 spring stop pins for the 60 mm pitch; hand or automatic feed.
  • Die set 470 × 333 mm with 2 diagonal Ø36 guide pillars in housings; punch, die and piercing pins in SKD11 hardened to 58–62 HRC, plates in S50C, standard components for a cost-effective build.
  • Dies to your drawing: send the part drawing, material and thickness, volume and press data and ZINITEK proposes the most economical die concept.