Precision Mold Design & Manufacturing

Scrap-Reuse Blanking Die for 165×195 mm Blanks

Model: N/A

3D model of Scrap-Reuse Blanking Die for 165×195 mm Blanks

Tính năng nổi bật

Single-station blanking die that cuts a 165 × 195 mm rectangular blank out of 1.2 mm steel offcuts: three knives shear three sides, the existing straight edge rests against a back-stop pin, and a slitting blade splits the scrap frame into two easy-to-remove pieces. View and rotate the animated 3D model right on the page.

  • Reuses scrap: offcuts from other stamping operations (with curled edges) are placed in the die with their straight edge against the Ø20 back-stop pin, so only three sides are cut — saving material and cutting edge alike.
  • Three segmented knives (2 × 195 mm, 1 × 165 mm) bolted and dowelled into a 165 × 195 × 70 knife holder; the die is made of four inserts on two die holders, so each piece can be reground or replaced on its own.
  • A scrap slitting blade on its own tower splits the U-shaped scrap frame into two L-shaped pieces during the cutting stroke; the operator pulls the scrap out to the front without reaching past the knives.
  • The 265 × 295 × 30 pressure pad hangs on four sleeve-type stripper bolts and clamps the sheet with 10 pin-guided polyurethane springs Ø30 × 65; four finger-guard plates enclose the pad’s pinch zone.
  • 630 × 480 mm die set with four Ø50 guide pillars and bushes, four height stop blocks and clamping lugs; the blank drops straight through the die inserts, die holders and lower shoe onto the bolster.
  • Knives, die inserts and slitting blade in SKD11 hardened to 58–62 HRC; shoes, holders and pad in S50C; screws, dowels and polyurethane springs are standard parts. Send a sample offcut or a blank drawing and ZINITEK will propose a scrap-reuse die for your shop.