Precision Mold Design & Manufacturing

Blanking Die for 149.8 × 158 mm Blanks with Blank Tray, 2 mm Sheet

Model: N/A

3D model of Blanking Die for 149.8 × 158 mm Blanks with Blank Tray, 2 mm Sheet

Tính năng nổi bật

Single-station blanking die for 2 mm steel sheet: 162 mm strip, 152.1 mm pitch, cutting a 149.8 × 158 mm blank that drops straight into a pull-out tray. Rotate the animated 3D model right on this page.

  • 8-piece sectional die in a die housing: worn sections are reground or replaced one at a time instead of remaking the whole die plate.
  • The blank passes through the die and backing plate and drops into a drawer-type tray between the two parallels; the operator pulls the tray out to collect the blanks.
  • The stripper hangs on 4 M20 shoulder bolts and is pushed by 12 rectangular-wire die springs seated in deep pockets in the punch holder and stripper, so the springs stay aligned in continuous running.
  • The strip runs between two guide rails and is located by a hole stop; the 4 Ø38 guide pillars stay in their bushes over the 16 mm working stroke.
  • Calculated cutting force ≈ 40 t (611 mm cut length, 2 mm steel); about 46 t including stripping, so a press of 80 t or more is recommended.
  • Punch and die in SKD11 tool steel hardened to 58–62 HRC; shoes and plates in S50C; standard pillars, bushes, springs and bolts. Send the drawing, material, thickness, volume and press data and ZINITEK will propose the die design.