Precision Mold Design & Manufacturing

Quick-Change Hot Forging Die Set with Wedge Clamping

Model: N/A

3D model of Quick-Change Hot Forging Die Set with Wedge Clamping

Tính năng nổi bật

Hot forging die set for a mechanical forging press: two 1240 × 495 mm die blocks that change quickly, held by a rear wedge, side wedge bars and M42 bolted clamps; guided by two Ø218 pillars. View and rotate the animated 3D model right on the page.

  • Upper and lower 1240 × 495 mm die blocks change quickly: loosen the front clamps, pull the block out to the front and fit a new block sunk for another forging.
  • Die blocks located by a rear wedge, a left side wedge bar, a right locating bar with M24 push screws and three front clamps tightened with M42 bolts.
  • Guided by two Ø218 pillars in Ø276 bushes at the back of the die; with a 300 mm stroke the pillars stay about 187 mm inside the bushes when fully open.
  • Animated 3D model driven by the crank: the upper holder opens and closes continuously, leaving an 8 mm gap between the die blocks at bottom dead centre.
  • Suggested materials: die blocks in H13/SKD61 hot-work tool steel (about 42–48 HRC); holders in S50C or cast steel; standard screws, bolts, pillars and bushes to keep the cost down.
  • Made to your drawing: send the forging drawing, material, volume and press data and ZINITEK will sink the impression and propose the die design.