Precision Mold Design & Manufacturing

Progressive Die for Copper Phase Contacts

Model: N/A

3D model of Progressive Die for Copper Phase Contacts

Tính năng nổi bật

Progressive Die for Copper Phase Contacts: 28 mm strip, 33 mm pitch. European-style standard build: lower shoe, die holder, stripper with its backing shoe, punch holder and upper shoe. Rotate the animated 3D model right on this page.

  • European-style standard build: lower shoe, die holder, stripper with its backing shoe, punch holder and upper shoe; pitch pilots and strip lifters carry the thin copper strip.
  • 28 mm strip, 33 mm pitch through 9 stations: pilot piercing, slitting, trimming, rib and dimple embossing, a burred hole, then cut-off with two 90° bends. The 3D model runs the crank at a steady 40 strokes/min: the strip lifts and feeds each pitch, slugs drop out of the die and the finished part leaves on the chute.
  • The stripper hangs on 6 M16 shoulder bolts with 6 Ø40 die springs and clamps the strip flat before the punches cut; stop blocks limit its travel to 6.6 mm. A spring-loaded pitch-check pin signals a misfeed.
  • Guided by 4 pillars Ø30; a press stroke of about 24 mm keeps the pillars engaged in their bushes throughout the cycle.
  • Cutting and forming parts in SKD11 tool steel hardened to 58–62 HRC; shoes and holder plates in S50C to keep cost down; standard screws, dowels, pillars, bushes and springs.
  • Order to your drawing: send the part drawing, material and thickness, volume and press data, and ZINITEK will propose the strip layout and die design.