Precision Mold Design & Manufacturing

Compound Die for Ø130/Ø80 Washers

Model: N/A

3D model of Compound Die for Ø130/Ø80 Washers

Tính năng nổi bật

Inverted compound die that pierces Ø80 and blanks Ø130 in one stroke for 1 mm sheet-steel washers: perfectly concentric hole and edge, flat parts. Rotate the animated 3D model right on this page.

  • Inverted compound layout: the Ø130 blanking punch in the lower die is also the Ø80 piercing die; the blanking die and piercing punch sit in the upper die — one stroke, one finished washer.
  • Hole and outside edge are cut at the same station, so they are perfectly concentric; the part is held between shedder and punch, so it stays flat.
  • A lower stripper on 6 springs lifts the strip off the punch; an upper shedder on 6 springs pushes the part back into the strip, which carries it out of the die where it is blown off.
  • The Ø80 slug drops straight through the punch, backing plate and lower shoe between the parallels; a stop pin locates the strip at a 133 mm pitch.
  • Guided by 4 pillars with bushes; cutting parts in SKD11 hardened to 58–62 HRC, plates in S50C to keep cost down; standard screws, dowels and springs.
  • Order to your drawing: send the part drawing, material and thickness, volume and press data, and ZINITEK will propose a simple, compound or progressive die at the right cost.