Precision Mold Design & Manufacturing

12-Station Progressive Die for a Floating Nut Cover

Model: N/A

3D model of 12-Station Progressive Die for a Floating Nut Cover

Tính năng nổi bật

12-station progressive die for a 1.6 mm sheet-steel floating nut cover: 95 mm strip, 33 mm pitch, two parts per stroke. Cutting, tab bending, offset forming, piercing and cut-off in one die; lifters raise the strip 11 mm before every feed. Rotate the animated 3D model right on this page.

  • 12 stations in sequence: H-window cutting, tab bending 45° then 90°, edge trimming and bridge forming, offset forming 45° then 90°, lip bending to 90°, piercing and cut-off into two mirrored parts.
  • 95 mm wide, 1.6 mm strip with a 33 mm pitch; 21 pilots locate the strip at every station before the punches work.
  • Stripper hung on 6 shoulder bolts and 14 die springs: it clamps the strip flat before the punches touch it and strips it off them as the die opens.
  • 17 lifters (10 with an edge-guide groove, 7 hollow pilot lifters) raise the strip 11 mm so the formed tabs and offsets clear the die before it feeds.
  • Guided by 4 Ø32 pillars and 6 Ø20 stripper guide posts; continuous crank motion, 50 mm recommended stroke; slugs drop straight through the die into the space between the parallels.
  • Cutting and forming parts in SKD11 hardened to 58–62 HRC; plates in S50C; standard pillars, bushes, springs, screws and dowels. Send a drawing and ZINITEK will propose the strip layout and die design.