
3D model
The view-only 3D model runs one full stroke: the crank turns at constant speed, the pressure pad clamps the offcut onto the die, three knives shear the blank on three sides while the slitter splits the scrap frame; the blank drops through the die and lower shoe onto the bolster and slides out sideways, the two scrap pieces are pulled out to the front and a new offcut is loaded against the back-stop pin before the die closes. The “Architecture view” button fades the frame plates to reveal the knives, die inserts, polyurethane springs, sleeve bolts and screw threads inside.
Main structure
Lower die: 630 × 480 × 50 shoe on two parallels, two die holders carrying four die inserts (2 × 195, 2 × 165 mm), Ø20 back-stop pin, two adjustable side stops, four Ø50 guide pillars, two height stop blocks and clamping lugs. Upper die: 630 × 480 × 50 shoe with spacer plate, four guide bushes in bush holders, a 165 × 195 × 70 knife holder with three knives, the scrap-slitter tower, a 265 × 295 × 30 pressure pad on four sleeve bolts with 10 polyurethane springs Ø30 × 65, four finger-guard plates and two height stop blocks.
Discuss a die for your part
Send a blank drawing or a sample offcut together with material, thickness, volume and press data, and ZINITEK will discuss the design and manufacture of a scrap-reuse die.
Project Gallery








