
3D model
Compound die for a 119.6 × 59.4 × 3.2 mm lever with 4 holes: the view-only 3D model runs a full cycle — the crank turns at constant speed, the stripper clamps the strip, the upper punch pushes the blank into the die while the 4 lower pins pierce the holes, the knockout lifts the part flush with the die face, and the skeleton carries it out until it drops at the die-plate end. “Architecture view” fades the frame plates to show the punch, die, piercing pins and springs inside.
Main structure
Upper die: 470 × 333 shoe, backing plate, punch holder, blanking punch that doubles as the piercing die, stripper on 4 die springs 40 × 40. Lower die: die plate with strip channel and 2 spring stop pins, blank-shaped knockout pad, 4 piercing pins Ø5.5–Ø6.5, backing plates, entry guide with 2 hold-down rails, lower shoe; 2 diagonal Ø36 guide pillars. The original design lets the piercing slugs exit upward through the punch and upper shoe; for manufacture ZINITEK recommends 0.2 mm piercing clearance per side and enlarged slug relief holes so the slugs never jam.
Discuss a die for your part
Send a drawing or reference sample with material, thickness, volume and press data and ZINITEK will discuss the design and manufacturing concept.
Project Gallery









