Precision Mold Design & Manufacturing

Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks

ZINITEK project: a swing blanking die whose air cylinder turns the blade unit ±18.75° to cut nested trapezoid blanks from 2 mm strip with zero scrap, with an animated 3D model. Discuss a die solution from your drawing or sample.

3D model of Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks

3D model

Swing blanking die for trapezoid blanks: the view-only 3D model runs two full strokes — steady crank motion, the upper blades cut along the +18.75° line, the die opens, the cylinder swings the blade unit to −18.75° against its stop, the strip feeds 500 mm and pushes the cut blank out of the die, and the next stroke cuts at the opposite angle. The “Architecture view” button fades the frame plates to show the blades, stripper, gas springs and swing mechanism inside.

Main construction

Lower die: shoe, 4 parallels, wear plates, pivot pin in its bushing, lower swing plate carrying 2 lower blades and 4 guide pins, 2 angle stops, air cylinder with lever and ball-joint rod end, 2 proximity sensors, stock support and edge guides. Upper die: upper swing plate carrying 2 upper blades and 4 bushings, stripper with 5 gas springs and 2 keepers, upper shoe; 4 Ø63.5 guide pins.

Discuss a die for your part

Send a drawing or sample with material, thickness, coil width, volume and press data, and ZINITEK will discuss the design and manufacturing approach.

Send a die design or manufacturing request

Project Gallery

Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks 1
Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks 2
Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks 3
Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks 4
Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks 5
Pneumatic Swing Die for Zero-Scrap Trapezoid Blanks 6