Precision Mold Design & Manufacturing

Compound Die with Positive Knock-out for a Two-Hole Link Plate

ZINITEK project: an inverted compound die for a 2.5 mm two-hole link plate with a positive knock-out at top dead centre, with an animated 3D model. Discuss a die solution from your drawing or sample.

3D model of Compound Die with Positive Knock-out for a Two-Hole Link Plate

3D model

Inverted compound die for a 25 × 87.7 × 2.5 mm two-hole plate: the view-only 3D model runs a full cycle — steady crank motion, the lower punch pushes the blank into the die while two punches pierce the holes, the stripper lifts the strip 6 mm, slugs drop through the shoe, the knock-out ejects the part at top dead centre and it is blown out at the exit side. The “Architecture view” button fades the frame plates to show the punches, dies and springs inside.

Main construction

Lower die: shoe, backing plate, punch holder, blanking punch / piercing die, a stripper on 14 springs hung on shoulder bolts, 8 strip guide pins. Upper die: blanking die, 2 piercing punches, a shedder on 4 springs with a Ø12 knock-out rod and limiting shoulder bolts, punch holder, backing plate, upper shoe; 2 Ø38 guide pillars.

Discuss a die for your part

Send a drawing or sample with material, thickness, volume and press data, and ZINITEK will discuss the design and manufacturing approach.

Send a die design or manufacturing request

Project Gallery

Compound Die with Positive Knock-out for a Two-Hole Link Plate 1
Compound Die with Positive Knock-out for a Two-Hole Link Plate 2
Compound Die with Positive Knock-out for a Two-Hole Link Plate 3
Compound Die with Positive Knock-out for a Two-Hole Link Plate 4
Compound Die with Positive Knock-out for a Two-Hole Link Plate 5