
3D model
Hot forging die set: the view-only 3D model shows the upper and lower holders, both die blocks, the wedge and clamp system and the guide pillars, with the press opening and closing. Switch on “Architecture view” to see through both holders.
Main structure
1900 × 1660 mm holders, two 1240 × 495 mm die blocks on backing plates, locked by a rear wedge, side wedge bars and three front clamps with M42 bolts. Two Ø218 guide pillars at the back with Ø276 bushes in the upper holder; M64 eye bolts for lifting and tie bars that hold both halves together in transport.
Discuss a die set for your forging
Send the forging drawing with material, volume and press data and ZINITEK will discuss the impression, die design and manufacturing.
Project Gallery








